Site Information

  • Image 1

Fan Mount (120mm x 25mm) - HDD bay


Product Description

Used to mount fans on the PSU side of a double wide Magnum case that has the same recessed look that the HDD cages have. It includes rubber pads to minimize vibration. It is possible to mount fans directly to the case where the 120mm holes are, so it is not required to mount fans.

This part only fits: M8/M10/T10/MH10/TH10

Product Reviews

Write Review

  1. Glad I got this

    Posted by Steve on 21st Mar 2014

    I almost didn't get this. I struggled a bit with understanding some of the features available for my M8. Some of the literature says this isn't required as you "can" mount the fans directly to the case but, if you have fans on both sides as I'm planning, they wouldn't look the same. This product sets the fan back as they would be if/when you mount fans to the left side of the case. It makes for a better and refined appearance. I'm very please that I purchased this.

  2. Good design...but needs a bit more depth

    Posted by Larry G. on 24th Aug 2013

    Ordered a few more of these fan holders for my new T10 case....order came fast and with good packing. They come with a good powercoat on them...takes most 120 fan with no issue...wish that the depth of the holder was a tad bit wider. I found that using the rubber or silicon anti vibration mounts supplied with a fan may not fit...I was able to get some of the Gelid anti vibration mounts in but had to really work to get them in other longer versions may not fit...however if you use the typical fan screws there is no problems mounting the fan....just an FYI.

  3. Excellent Quality

    Posted by Adam Johnessee on 6th Aug 2012

    I got these to make my TH10 look similar on each side aside from my 2 Blu-ray burners. They work perfectly for any 120mm fan and gave my case that finally look that I needed to be complete.

Find Similar Products by Category