Bottom accessory mounts with tubing management provide a more solid surface to mount pumps too, but have the added benefit of pre-drilled pass-throughs. They are made from .063" aluminum, and are recessed to clear screws on the underside. 120mm mounts are sold in pairs, and the 140mm mount is sold individually. Pass-throughs are 1’’ (25.4mm) wide.
Customers also viewed
Posted by Joe on 29th Mar 2015
This I a Great product if you are running 2 loops. What I did was make the mistake of buying the 140' & I needed the 120's.
It turned out to be a good thing so that I know can put 2 Holes in the 120's using the grommet from the 140's. Cost a bit more, but worth to me!!!
Posted by ali on 16th Mar 2015
a quick and easy way to run your pipework through your case,using the fan cut outs in the motherboard area,roof or floor,used in the STH10 case,mades it look clean and tidy as the pipework goes through the case panels.
Posted by Unknown on 9th Jan 2015
As usual, fantastic finish and fit. The only thing I wish was that they had option for hole at off-set to one end and/or in the middle but I surely cannot complain. This is another Caselabs product which means you get the usual great product.
Tubing Management (pair 120mm)
Posted by Ray M on 15th Apr 2013
Great product. Only issue I had with it for my build is I wish it was flat. The raised center section for where I mounted my pumps forced me to mount it on the underside of the case. However this was because where I had to mount my pumps for this build and the plate itself is great!
Nice finishing look for passing through tubing between chambers.
Posted by Ronsanut on 14th Jun 2012
Just the right touch to pass tubing without having to cut and install panel couplings.